- 4" x 150' Floor & Pavement Marking Tape
Our 4" x 150' pavement marking tape rolls are designed to stripe asphalt & concrete surfaces, parking garages, warehouse floors, factory floors, roads and any other area where high visibilty delineation is needed. Available in Yellow, White and Blackout. (blackout tape is only available in the standard grade)
Our tape is simple to install with no special equipment or contractor required. If the tape gets damaged it just takes a few minutes to replace the damaged piece. It is as thick as normal parking lot paint and has a durable, reflective surface. The tape's aggressive adhesive and conformable foil backing insure that when properly applied your reflective white or yellow lines will remain in place. It can be removed if necessary. Longevity depends on traffic flow and proper installation. The tape performs best on smooth surfaces where all of the tape can make contact with the surface. Parking lots or warehouses with moderate to light traffic often get years of service out of the tape. The tape can handle traffic rolling straight over it, however, the life of the tape will be greatly reduced in areas where tires twist the tape excessively. For large projects we suggest you install a roll of the tape first to determine if it will meet your requirements. Sand, dirt, oil or sealcoat with prevent this product from adhering properly.
To install our striping tape simply apply it to a clean, dry surface and press it on. The temperature should be in excess of 50 degrees. Dry, clean, sun warmed asphalt or cement is ideal. Better adhesion can be achieved by going over the tape with a heavy roller or by using your vehicle tire. When using a vehicle be careful not to turn the steering wheel while on the fresh tape. Also, avoid applying the tape to damp asphalt or cement. It is best to apply when it has not rained in 48 hours. After application the tape is ready for traffic. Full curing occurs after about 48 hours and it is best if it does not rain during this time as well. For heavy traffic areas or where tires will be twisting on the striping try our "preformed thermoplastic striping" by clicking on the link to the left.
We carry the foil backed pavement tape in both WHITE and YELLOW in STANDARD and HEAVY DUTY grades and in BLACK in standard grade only. Our HEAVY DUTY grade is thicker and more reflective. It also contains more adhesive. Click below to make your choice.
We also carry this product in 6", 8", 10" and 12" rolls. We carry the standard and heavy duty grades. The prices are $89.99/$99.99 for the 6" rolls, $119.99/$139.99 for the 8" rolls, $149.99/$169.99 for the 10" rolls, and $179.99/$199.99 for the 12" rolls. (call to order these sizes)
CLICK HERE FOR MORE PHOTOS OF THIS PRODUCT
CLICK HERE FOR INSTALLATION INSTRUCTIONS FOR THIS PRODUCT
Our tape is simple to install with no special equipment or contractor required. If the tape gets damaged it just takes a few minutes to replace the damaged piece. It is as thick as normal parking lot paint and has a durable, reflective surface. The tape's aggressive adhesive and conformable foil backing insure that when properly applied your reflective white or yellow lines will remain in place. It can be removed if necessary. Longevity depends on traffic flow and proper installation. The tape performs best on smooth surfaces where all of the tape can make contact with the surface. Parking lots or warehouses with moderate to light traffic often get years of service out of the tape. The tape can handle traffic rolling straight over it, however, the life of the tape will be greatly reduced in areas where tires twist the tape excessively. For large projects we suggest you install a roll of the tape first to determine if it will meet your requirements. Sand, dirt, oil or sealcoat with prevent this product from adhering properly.
To install our striping tape simply apply it to a clean, dry surface and press it on. The temperature should be in excess of 50 degrees. Dry, clean, sun warmed asphalt or cement is ideal. Better adhesion can be achieved by going over the tape with a heavy roller or by using your vehicle tire. When using a vehicle be careful not to turn the steering wheel while on the fresh tape. Also, avoid applying the tape to damp asphalt or cement. It is best to apply when it has not rained in 48 hours. After application the tape is ready for traffic. Full curing occurs after about 48 hours and it is best if it does not rain during this time as well. For heavy traffic areas or where tires will be twisting on the striping try our "preformed thermoplastic striping" by clicking on the link to the left.
We carry the foil backed pavement tape in both WHITE and YELLOW in STANDARD and HEAVY DUTY grades and in BLACK in standard grade only. Our HEAVY DUTY grade is thicker and more reflective. It also contains more adhesive. Click below to make your choice.
We also carry this product in 6", 8", 10" and 12" rolls. We carry the standard and heavy duty grades. The prices are $89.99/$99.99 for the 6" rolls, $119.99/$139.99 for the 8" rolls, $149.99/$169.99 for the 10" rolls, and $179.99/$199.99 for the 12" rolls. (call to order these sizes)
CLICK HERE FOR INSTALLATION INSTRUCTIONS FOR THIS PRODUCT
Click To Enlarge
- Item #: 4pm150
